Functional requirements

The system must have been reset when the inflation pressure was correct; otherwise, reliable signaling of a flat tire is not ensured. Always use wheels with TPM electronics to ensure that the system will operate properly. Reset the system after each correction of the tire inflation pressure and after every tire or wheel change.

    See also:

    Switching on/off
    Press the button. ▷ On: the LED lights up. ▷ Off: the LED goes out. The system can issue warnings at speeds above approx. 40 mph/65 km/h. The state is stored for the remote contro ...

    Switching on/off manually
    Switching on/off manually Press the button. ▷ On: the LED lights up. ▷ Off: the LED goes out. ...

    Programming
    Programming 1. Memory buttons 2. LED Fixed-code hand-held transmitters 1. Switch on the ignition, refer to page 61. 2. Initial setup: Press both outer memory buttons 1 for approx. 20 seconds ...