Activating

Switch position ignition switched with the ignition switched on.

The turning lamps are automatically switched on depending on the steering angle or the use of turn signals.

To avoid blinding oncoming traffic, the Adaptive Light Control directs light towards the front passenger side when the vehicle is at a standstill.

When driving in reverse, only the turning lamp is active.

    See also:

    Following part replacement
    The same breaking in procedures should be observed if any of the components mentioned above have to be renewed in the course of the vehicle's operating life. ...

    Radio Data System RDS
    In the FM waveband, additional information is transmitted via RDS. If the reception conditions are good, the station names are shown on the Control Display. Where reception is poor or in the event ...

    Parking lamps
    Switch position : the vehicle lamps light up on all sides, e.g., for parking. Do not use the parking lamps for extended periods; otherwise, the battery may become discharged and it would then ...