Damage to safety belts

In the case of strain caused by accidents or damage:

Have the safety belts, including the safety belt tensioners, replaced and have the belt anchors checked.

belts Checking and replacing safety belts

Have the work performed only by your service center; otherwise, it cannot be ensured that this safety feature will function properly.

    See also:

    Switching on/off
    Press the button. On: the LED lights up. Off: the LED goes out. The system can issue warnings at speeds above approx. 40 mph/65 km/h. The state is stored for the remote control currentl ...

    Checking the pressure
    Only check the tire inflation pressure when the tires are cold. This means after driving no more than 1.25 miles/2 km or when the vehicle has been parked for at least 2 hours. When the tires a ...

    Hydroplaning
    On wet or slushy roads, a wedge of water can form between the tires and road surface. This phenomenon is referred to as hydroplaning. It is characterized by a partial or complete loss of contact ...