Initializing after a power failure

After a power failure during the opening or closing process, the roof can only be operated to a limited extent.

Initializing the system

The system can be initialized when the vehicle is stationary and the engine is running.

During the initialization, the roof closes without pinch protection.

Monitor the closing process and make Danger of pinching

Monitor the closing process and make sure that the closing path of the glass sunroof is clear; otherwise, injuries may result.

Press the switch up and hold it

Press the switch up and hold it until the initialization is complete:

▷ Initialization begins within 15 seconds and is completed when the sunroof is completely closed.

▷ The roof closes without pinch protection.

    See also:

    Notes
    Steam jets or high-pressure washers When using steam jets or high-pressure washers, hold them a sufficient distance away and use a maximum temperature of 140 ℉/ 60 ℃. Holding th ...

    Remove attached parts following use
    Remove unneeded auxiliary mirrors, roof or rear luggage racks after use. Attached parts on the vehicle impair the aerodynamics and increase the fuel consumption. ...

    Notes
    > Reception may not be available in some situations, such as under certain environmental or topographic conditions. The satellite radio cannot influence this. > The signal may not be availabl ...