Preparation

1. Check whether the battery of the other vehicle has a voltage of 12 volts and approximately the same capacitance in Ah. This information can be found on the battery.
2. Switch off the engine of the assisting vehicle.
3. Switch off any electronic systems/power consumers in both vehicles.

There must not be any contact between Bodywork contact between vehicles
There must not be any contact between the bodies of the two vehicles, otherwise there is a danger of shorting.◀

    See also:

    Brightness
    Setting the brightness To set the brightness of the Control Display: 1. "Settings" 2. "Control display" 3. "Brightness" 4. Turn the controller until the desired br ...

    General information
    Refuel promptly Refuel no later than at a range of 30 miles/50 km, or operation of the engine is not ensured and damage may occur.◄ ...

    Tail lamps, bulb replacement
    At a glance 1 Turn signal 2 Backup lamp 3 Inside brake lamp 4 Tail lamp 5 Tail lamp/brake light Turn signal, tail lamp and brake lamp Follow the general instructions on lamps and bulbs. 21- ...