Tail lamps

▷ Turn signal, brake lamp: 21-watt bulb, P21W.

▷ Brake force display: 21-watt bulb, P21W.

▷ Backup lamp: 16-watt bulb, W16W

▷ Tail lamp: LED technology.

Contact your service center in the event of a malfunction.

Arrangement of tail lamps

Arrangement of tail lamps
Arrangement of tail lamps

1 Tail lamp
2 Brake force display
3 Brake lamp
4 Tail lamp/side marker lamp
5 Backup lamp
6 Turn signal

Turn signals, brake lamps and backup lamps

The bulbs are integrated in a single bulb holder.

1. Open the side panel in the cargo area.
2. Remove the first aid kit and warning triangle if necessary. Fold up the insulation.

Turn signals, brake lamps and backup
Turn signals, brake lamps and backup lamps

3. Press the button, arrow 1, down, press the catches, arrows 2, outward slightly, and remove the bulb holder.

4. Apply gentle pressure to the P21W bulb while turning it to the left for removal and replacement.

Remove the W16W bulb and replace.

5. Re-engage the bulb holder so that it audibly clicks into place.

6. Remount the side panel.

Brake Force Display

1. Carefully remove the cover in the tailgate panel with a screwdriver.

2. Push the catch on the bulb holder to the left,

2. Push the catch on the bulb holder to the left, arrow, and remove it.

3. Apply gentle pressure to the bulb while turning

3. Apply gentle pressure to the bulb while turning it to the left for removal and replacement.

4. Re-engage the bulb holder so that it audibly clicks into place.

5. Before installing the cap, unclip the cargo area lamp.

Then lay the cap on its upper side and close it, refer to arrow.

6. Position the cargo area lamp and clip it in,

6. Position the cargo area lamp and clip it in, refer to arrow.

License plate lamps

License plate lamps

These lamps are made using LED technology.

Contact your service center in the event of a malfunction.

Center brake lamp

This lamp uses LED technology for operation.

Contact your service center in the event of a malfunction.

    See also:

    For the 530i, 535i, 550i, 525d, 530d and 535d: check oil level
    The concept The oil level is monitored electronically and displayed on the Control Display. Requirements ▷ The engine must be running and warm after the vehicle has been driven for at lea ...

    Measurement
    Measurements are made by ultrasound sensors in the bumpers. The range is approx. 6 ft/2 m. An acoustic warning is first given: ▷ By the front sensors and two rear corner sensors at approx ...

    Display in the instrument cluster
    The selected speed is displayed in the speedometer. Green: the system is actively braking the vehicle. Orange: the system is on standby. ...