Service data in the remote control

Information on the required maintenance is continuously stored in the remote control. Your service center will read out this data and suggest the right array of service procedures for your vehicle.

Therefore, hand your service specialist the remote control that you used most recently.

Make sure the date is set correctly; otherwise, the effectiveness of CBS Setting the correct date
Make sure the date is set correctly; otherwise, the effectiveness of CBS Condition Based Service is not ensured.◀

    See also:

    Engine stop
    The engine is switched off automatically during a stop under the following conditions: Manual transmission: ► Neutral is engaged and the clutch pedal is not pressed. ► The driver' ...

    Putting into operation after a power failure
    Putting the parking brake into operation The parking brake should only be put into operation again if it was manually released due to an interruption in the supply of electrical power. Otherw ...

    Display on the Control Display
    Switching on the backup camera via iDrive With Top View switched on: "Rear view camera" The backup camera image is displayed. The setting is stored for the remote control currently ...