Checking the coolant level
1. Do not open the hood until the engine has
cooled down.
2. Turn the expansion tank cap counterclockwise
slightly to allow any accumulated pressure
to escape; then continue turning to
open.
3. The coolant level is correct if it is between
the maximum and minimum marks in the
filler neck, refer also to the diagram next to
the filler neck.
4. If the coolant is low, slowly add coolant up to
the specified level; do not overfill.
5. Turn the cap until there is an audible click.
6. Have the cause of the coolant loss eliminated
as soon as possible.
Disposal
Comply with the
appropriate environmental
protection regulations when disposing
of coolant additives.
See also:
Rear
In the center armrest.
Pull the center armrest forward at the strap.
To open: press the button.
To close: push both covers back in, one after the
other.
Pushing back the covers
Push back the ...
Vehicle equipment
All standard, country-specific and optional
equipment that is offered in the model series is
described in this chapter. Therefore, equipment
is also described that is not available in a vehicle, ...
Engine stop
The engine is switched off automatically during
a stop under the following conditions:
Manual transmission:
► Neutral is engaged and the clutch pedal is
not pressed.
► The driver' ...